Aftermarket Fuel Injection improvements on the DUCATI 1299 Panigale are usually expensive and complicated. The BoosterPlug is a better and proven alternative.
The BoosterPlug is the best way to sort out the fuel injection on your bike - without the high cost and the complicated programming of a Power Commander, and without the need to install multiple parts all over your bike.
The BoosterPlug is installed in less than 10 minutes. It plugs directly into your bikes wire harness using original connectors – no cutting or splicing, and no additional parts needed.
Inexpensive, easy installation, proven results:
- Improved and softer throttle response
- Harder acceleration.
- The end of the dreaded low speed surging
- Stronger idle - no more stalling problems
- Aftermarket exhaust backfire reduced or eliminated
This version of the BoosterPlug covers all versions of the DUCATI 1299 Panigale from 2017 and newer.
If you have an older Panigale 1299 model, you can find the BoosterPlug for it in the related products below.
Note: The Ducati Panigale series is using the same temperature sensor for the fuel injection calculations as for the temperature readout in the dashboard. (Most other brands have seperate sensors).
This means that your dashboard display will show 20°C / 35°F lower than actual ambient temperature when you install the BoosterPlug.
There's no way around this, and it's probably not an issue for most people, but we want you to be informed about it.
General Installation Instructions
Bike Specific Installation Instructions
