Aftermarket fuel Injection tuning modifications on the Yamaha Ténéré 700 are mostly expensive and complicated. The BoosterPlug is a better and proven alternative.
Did you think the complicated Power Commander was the only way to sort out the fuel injection tuning on your bike ? The BoosterPlug will offer the better solution at a fraction of the cost.
The BoosterPlug is installed in less than 10 minutes. It plugs directly into your bikes wire harness using original connectors – no cutting or splicing - no need for additional aftermarket tuning mods.
Release the full potential in your motorcycle:
- Fix the snatchy throttle response problem
- Harder acceleration
- Say goodbye to the low speed surge issue
- Stronger idle - no more stalling problems
- Minimize the backfire in your aftermarket exhaust
This version of the BoosterPlug covers all Yamaha Ténéré 700 models from 2019 and 2020)
Please note that we can not build a BoosterPlug for the "2021 and newer" model due to new emission regulations.
You can see the detailed explanation here.
Note: The Yamaha Ténéré 700 is using the same temperature sensor for the fuel injection calculations as for the temperature readout in the dashboard. (Most other brands have seperate sensors). This means that your dashboard display will show 20°C / 35°F lower than actual ambient temperature when you install the BoosterPlug. There's no way around this, and it's probably not an issue for most people, but we want you to be informed about it.
